A NEW METHOD OF RF TRANSMISSION      

"THE POYNATRON"

Since I was about 10 years young when I started to get interested in Crystal sets and Shocking coils and RF in general and over the years now 57 have gained a lot of experience and used that in my vocation to my rewards.......

The dipole has  many problems and I think it's 120 year service will soon come to an end as Technology now goes forward....When you take a look at the Voltage and Current distribution along the dipole "in resonance" you can see that as the current goes up the quarter wave section it reduces due to inductance and the voltage increases by a factor of the "Q" of the thing and likewise because the whole thing is resonant the current increases by the "Q"..... So we have a high current and a high voltage but they are out of phase and is the result of the near field.... The near field is something we don't want because it means that only when both are in phase will the most power be sent in the direction you want so a lot of power is wasted and most important is the fact that vectorially other angles of radiation have been lost in other directions hence a wide diverging signal is the net result.... We do know that because we have a "Q" we then must have a bandwidth problem.... adding other elements do not 100% cure this because these have the same defects.... We know that there is an atomic balance of E to H field and that is 1 volt to 2.65m/A (377 ohms)...

By Conclusion we have to design something that will send power from A to B without the INVERSE SQUARE LAW and I know it can be done and will explain my logic to this conclusion..... There is NO difference between 8KHz RF and light both are E and H fields.... We can make Lasers.... That are nearly perfect so why not an RF interface such that it is born parallel not born expanding outwards like the di-pole....

We first have to control the "E" field....Then the "H" field (this one has been my problem).... Then adjust the Phase of each.... Then adjust the Atomic levels... And the Question of how wide we want the beam to be to be of any use as a Radio Communication media.... If you produce a high power beam it will probably ionize and would be dangerous anyway... Also a pin head beam could not be set up to a pin head receiver easily so lots of experimentation and a balancing act has to take place on beam diameter....The radiation must not be isotropic.

This type of system CANNOT be detected outside the beam other than leakage from the TX coax lines..... This brings in the fact that many people can work on the same frequency without interference but it is pure point to point communication..... This would be the ideal case of a remote repeater TX sent up to a hill location and little hardware to convert it to OMNI-DIRECTIONAL... Another side effect with my design is that a di-pole will NOT see it at all....

Note that No aerial ever will actually have a gain.......1 Watt is Always 1 Watt.... but if 1 Watt is sent forward in a parallel E and H format with nothing bending then it has to go forward in one direction..... These things have been known over 120 years.... I have spent 3 years trying to think of how to do this but I want to find all the answers before going public.

The narrow beam model does now open the door to scanning for Land Mines at say 100 feet away being into ATV and Radar will present no problem or Medical low power RF scanner and many more other things...  Its just time finding out the dielectrics of certain materials and the reflective index.

Another good side effect of having the "E" field a lower voltage and area it will go through ground much easier yet another useful tool and at lower frequencies through metal bodies. Below 100Khz.

NOTE:- the radiation pattern produced does not look like the standard model for Transverse electromagnetic propagation (TEM).

Oxygen only has a loss of 0.007db/km at 10GHz.

Rain attenuation is only 1db/km with rainfall of 25mm/HOUR........ falling to 0.01db/km at 1mm/HOUR

I had to give it a name so it's this one  "POYNATRON" and give respect to the original theory...